PanelDue

PanelDue

An LCD touch display to make operations intuitive. It comes in three sizes 4.3”, 5”, and 7”.


Features

  • The control board and firmware support 3 screen sizes: 4.3″, 5″, and 7″, at two resolutions: 480×272 (4.3-inch displays) or 800×480 pixels (5- and 7-inch displays). Note that the lower resolution of the 3” display means that it cannot display as much information on the screen – for example, a maximum of 4 extruders, as shown in the picture
  • Duet is now supplying the 5-inch and 7-inch LCD and PanelDue as an integrated unit: the PanelDue 5i or PanelDue7i
  • 5V power from the host 3D printer
  • 2-wire async serial interface with 3V signal level (5V tolerant input)
  • Connections to the onboard micro SD card socket as well as the PanelDue serial and power connections are all available via a 10-way ribbon. A 300mm long ribbon cable (maximum recommended length) is supplied
  • 4-wire cable to connect the PanelDue to your controller board for the serial and power connections. This cable is also supplied (1m long)
  • The control board without a screen is also available; however, a 4.3”, 5” or 7” SSD1963 LCD panel is required